Dash Sensor Removal
CAUTION:
• Do not damage the sensor wiring.
• Do not install used SRS parts from another car.
When repairing an SRS: use only new parts.
• Carefully inspect the dash sensors for signs of being dropped or improperly handled, such as dents, cracks or deformation.
1. Disconnect the battery negative cable, then the positive cable.
2. Install the short connector (RED) on the airbag (see page 23-274).
3. Remove the footrest and left door sill molding, then pull the carpet back, and remove the dash sensor protector.
4. Remove the 2 mounting bolts, then remove the dash sensor.