Cable Reel Removal
AWARNING Store a removed airbag assembly with the pad surface up. If the airbag is improperly stored face down, accidental deployment could propel the unit with enough force to cause serious injury.
CAUTION:
• Carefully inspect the airbag assembly before installing it. Do not install an airbag assembly that shows signs of being dropped or improperly handled, such as dents, cracks or deformation.
• Always keep the short connector on the airbag connector when the harness is disconnected.
• Do not disassemble or tamper with the airbag assembly.
1. Disconnect the battery negative cable and then the positive cable.
2. Make sure the wheels are aligned straight ahead.
3. Remove the dashboard lower cover and knee bolster.
4. Install the short connector (RED) on the airbag.
5. Remove the airbag assembly from the steering wheel (two T30 TOW bolts), then remove the steering wheel nut.