Cruise Control

Main Switch Test

CAUTION:
•   All SRS electrical wiring harnesses are covered with yellow outer insulation.
•   Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
•   Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

NOTE: Be careful not to damage the switch and the instrument panel.
1. Carefully pry the switch out from the instrument panel and disconnect the connector.

2. Check for continuity between the terminals in each switch position according to the table.

•   If there is no continuity, replace the switch.