Horns
Switch Test
10. Check for continuity between the horn positive terminal and the steering column shaft with the horn switch pressed. There should be no continuity.
• If there is continuity, replace the cable reel.
• If there is no continuity, remove the nut and the 4 screws, then remove the steering wheel cover.
Replace the horn switch.
11. Reinstall the steering wheel (see Section 17).
Switch Test (Without SRS)
1. Remove the steering wheel, then turn it over.
2. Check for continuity between the hub core and the contact ring, or the hub core and the BLU/RED lead for cars equipped with cruise control, according to the table.
3. If OK, reinstall the steering wheel, then test the combination switch.