Interlock System
Key Interlock Solenoid Test
CAUTION:
• All SRS electrical wiring harnesses are covered with yellow outer insulation.
• Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273).
• Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
1. Remove the dashboard lower cover.
2. Remove the knee bolster (see Section 20).
3. Disconnect the 7-P connector from the main wire harness.
4. Check for continuity between the terminals in each switch position according to the table.
5. Check that the key cannot be removed when thebattery is connected to the A and B terminals.
• If the key cannot be removed, the key interlock solenoid is OK.
• If the key can be removed, replace the steering lock assembly (key interlock solenoid is not available separately).