Rear Bearing Replacement (Mitsubishi Type)

1. Pull off the rear bearing.
• Make sure the tips of the bearing puller jaws are thin enough to fit between the bearing and the slip rings.
•   Do not reuse the bearing.

2. Use a hand press to install the new bearing. Apply pressure only on the inner race to avoid damaging the bearing.

Alternator Reassembly (Mitsubishi Type)

1. Push the brushes in so the holes in them line up with the hole in the housing, then insert a pin or drill bit (about 1.8 mm diameter) to hold them there.

2. Heat the rear bearing seat in the rear housing as described on page 23-120. After heating, continue immediately with assembling before the rear bearing seat cools completely.

3. Put the rear housing/stator assembly and drive end housing/rotor assembly together, tighten the four through bolts, pull out the pin, and plug the brush access hole.

4. After assembling, turn the pulley by hand to make sure the rotor rotates smoothly and without noise.