Ignition System
Distributor Reassembly
Reassemble the distributor shaft and housing in the reverse order of disassembly.
1. Install the rotor, then turn it so that it faces in the direction shown (toward the No. 1 cylinder).
2. Slip the thrust washer and coupling onto the shaft.
3. Check that the rotor is still pointing toward the No. 1 cylinder, then align the index mark on the housing with the index mark on the coupling.
4. Drive in the pin and secure it with the pin retainer.
Ignition Wire Inspection and Test
CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wires; you might break them inside.
1. Check the condition of the wire terminals. If any terminal is corroded, clean it, and if it is broken or distorted, replace the wire.
2. Connect ohmmeter probes and measure resistance.
Ignition Wire Resistance:
25,000 ohms max. at 20°C (70°F)
3. If resistance exceeds 25,000 ohms, replace the ignition wire.