NOTE: • If an intact airbag assembly has been removed from a scrapped car or has been found defective or damaged during transit, storage or service, it should be deployed (see section 23). • Before removing the gearbox, remove the ignition key to keep the steering shaft from turning. • After installing the gearbox, check the wheel alignment and adjust if necessary. CAUTION: • All SRS electrical wiring harnesses are covered with yellow outer insulation. • When disconnecting the SRS wire harness, install the short connector on the airbag, then disconnect the wire harness (see page 23-297). • Replace the entire affected SRS harness assembly if there is an open circuit or damage to the wiring.