CAUTION: • All SRS electrical wiring harnesses are covered with yellow outer insulation. • Before disconnecting the SRS wire harness, install the short connector on the airbag (see page 23-273). • Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
1. Check that the index mark of the indicator aligns with the N mark of the shift indicator panel with the transmission in NEUTRAL.
2. If not aligned,remove the center console. (see page 20-72).
3. Remove the shift indicator panel mounting screws and adjust by moving the panel.
NOTE: Whenever the shift indicator panel is removed, reinstall the panel as described above.